Cooper&Hunter CH09ACE230V Manual y guía del usuario descargar pdf (Pagina 18)

After putting through the power, press "ON/OFF" button on remote controller to

turn on the air conditioner.

Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN,

HEAT.

Press "▲" or " " button to set your required temperature. (Temperature can’t

be adjusted under auto mode).

Press "FAN" button to set your required fan speed: auto, low, medium and high

speed.

Press "SWING" button to select fan blowing angle.

Operation guide

▲

Replacement of batteries in remote controller

1. Press the back side of remote controller marked

with " ", as shown in the g, and then push out

the cover of battery box along the arrow direction.

2. Replace two 7# (AAA 1.5V) dry batteries, and

make sure the position of "+" polar and "-" polar

are correct.

3. Reinstall the cover of battery box.

signal sender battery

Cover of battery box

remove

reinstall

● During operation, point the remote control signal sender at the receiving

window on indoor unit.

● The distance between signal sender and receiving window should be no

more than 8m, and there should be no obstacles between them.

● Signal may be interfered easily in the room where there is uorescent lamp

or wireless telephone; remote controller should be close to indoor unit during

operation.

● Replace new batteries of the same model when replacement is required.

● When you don’t use remote controller for a long time, please take out the

batteries.

● If the display on remote controller is fuzzy or there’s no display, please

replace batteries.

NOTICE

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 28 29

Sin comentarios

Cooper&Hunter CH09ACE230V Manual y guía del usuario Pagina 18